|
|
|
|
|
||||||||
|
|
|||||||||
| Home | Forums | Register | Gallery | FAQ | Calendar |
| Retailers | Community | News/Info | International Retailers | IRC | Today's Posts |
 |
|
|
Thread Tools |
November 6th, 2008, 10:58
|
#1 |
|
How to open stock on ICS Mp5 A2?
Hello guys I bought an ICS all metal SW5 AEG with the full stock. I can't figure out how to open the stock to replace the battery. There doesn't appear to be any mechanism to manipulate to open the butt plate, as the instructions ask me to do. The only thing I can figure out is that maybe I'm supposed to take the entire stock off by unscrewing the bolt on the side, which I've done, but then when I do that there's nowhere to put the battery in (the opening from the front is too small).
Is anyone familiar with this model and how the battery is inserted? Its the top one on this page http://www.airsoftnw.com/modules.php...w&CID=129&KID= thanks, -wesley |
|
|
|
|
November 6th, 2008, 11:07
|
#2 |
|
aka coachster
|
doesn't the rubber butt end just slide off? are you also sure it's not front wired in the hand guard? just remove the front pin on the hand guard to check.
|
|
|
|
|
November 6th, 2008, 11:07
|
#3 |
|
put pressure on the rubber butt plate downward, it should snap.
__________________
Burnaby / Vancouver area Age verifier  |
|
|
|
|
November 6th, 2008, 13:24
|
#4 |
|
Just take the rubber cover off of the end of the butt and slide the plastic cover either up or down and it will reveal the battery compartment.
I went through the same thing, the instructions kind of leave out the sliding bit.
__________________
 
|
|
|
|
 |
|
||||||
| Bookmarks |
|
|
 |
|
