TM Hi-Capa 5.1 Assembly

[Affliction]

Well my slide locked back (couldn't manage to get it back forward) so I unscrewed the 2 large silver screws on the hand-grip area. The back of the gun (that you have to hold to shoot) sprung out so I removed the spring above the trigger-guard and it lifted out.

My issue is that I cannot seem to put the gun back together. The slide is intact and fine but I'm having a difficult time putting the frame back together properly.



How do I put these 2 parts back together properly? If I just re-assemble them as is, the hammer won't stay back.

Thanks.
-VM

[Endymion]

At the bottom rear of your grip frame there's a pin holding in the hammer spring assembly. Pull it out and remove the leaf springs and you'll have an easier time putting the receiver and grip frame back together.

[Affliction]

I removed the pin and the hammer spring assembly piece slid out the bottom of the grip.

What is a leaf spring? Doesn't seem to be any easier but I can remove the 3 prong thing now :O
-VM

[Endymion]

The 3-prong plate is your spring. With that removed you should find assembly the receiver and pistol grip easy. When you place that plate back on afterward, make sure the right and centre prongs are on top of sear/hammer components.

[Affliction]

Typically when I pull back the hammer, the silver nub to the of it left goes down and the silver nub on the right goes up.

Right now, I can pull back the hammer, but the left nub will not go down (The right goes up however).
-VM