Aug Tear down?

[Voodoo]

My buddy is planning on doing a Carbonfiber overlay on the main body of his Aug and he need to know someting. Is there any reason why the Aug has to be sepporated in half to get at the internals? This is not about the barrel hop up assemble but the main body, do you have to crack it open down the seem for any reason ie. general maintenance or if there is a break down in the mech box.

Thanks

[dontask]

http://www.airsoftcanada.com/showthr...&highlight=aug

[Lakonian]

Originally Posted by Voodoo

My buddy is planning on doing a Carbonfiber overlay on the main body of his Aug and he need to know someting. Is there any reason why the Aug has to be sepporated in half to get at the internals? This is not about the barrel hop up assemble but the main body, do you have to crack it open down the seem for any reason ie. general maintenance or if there is a break down in the mech box.

Thanks

NO!!! You remove the pin in the rear , and everything should slide out! DON'T CRACK ANYTHING OPEN

[Voodoo]

i did not do ANYTHING untill i saw a few post. Thank you VERY much. It may have sounded like a dumb question but it would look way better if it was 1 continuous piece of carbonfiber insted of having a seem.

Again thank you for giving a post, i was starting to loss hope in the thread.

[dontask]

u... didnt read that linked thread i posted?
it was all about how to get the gearbox out...

[Voodoo]

i just got home from work and i started the thread like 3 days ago. Thanks