CYMA MP5 Cocking handle replacement

[deltastrike]

Hello

1) Any tip on the Cocking handle replacement (is it screwed in place ???) Check the picture

2) Can we replace the whole part ? So far i have seen only the Cocking Handle that is offered.

3) Does anyone know if we can buy the internal shaft ?

4) How to remove that internal shat so that it would be easier to replace the cocking handle ?

5) Any TM/Cyma MP5 parts retailers that you know of beside Redwolf, Evike, Ehobby, UN company ????

Thanks

https://imgur.com/a/zI3FZbk

[RainyEyes]

The cocking handle is disassembled by removing the upper receiver from the handguard and sticking a long philips head screwdriver down the FRONT IRON SIGHT housing. You need to remove the handguard pin as well in order to disassemble the front iron sight and access the screw to remove the charging handle.

Check tigerhk111, ebay, asiaairsoft.

Other MP5 charging handles may not fit with CYMA specific MP5's. e.g. g&g charging handle may not fit on a MP5 mock bolt.