|
|
|
|
|
||||||||
|
|
|||||||||
| Home | Forums | Register | Gallery | FAQ | Calendar |
| Retailers | Community | News/Info | International Retailers | IRC | Today's Posts |
 |
|
|
Thread Tools |
December 22nd, 2013, 00:01
|
#1 |
|
Screw stuck IN motor
Hey, im going to sound like an idiot here but... i was taking apart my G&P m4 to replace the selector plate as the old one was broken and while unscrewing the motor connectors the screw had got stuck on top of the motor. I tried pliers and and a screwdriver but it fell Into the motor like inside of it and now the motor is jammed.
Anyone had this happen before? or know i i can get the damn screw out? |
|
|
|
|
December 22nd, 2013, 00:08
|
#2 | |
|
Take the motor appart?
But if you never did that, you might have a hard time and even worst when trying to reassemble and time it properly...
__________________
Quote:
|
|
|
|
|
|
December 22nd, 2013, 00:10
|
#3 |
|
Never even known it could be taken apart :/
|
|
|
|
|
|
December 22nd, 2013, 00:11
|
#4 |
|
Not Eye Safe, Pretty Boy Maximus on the field take his picture!
|
Just take the end bell off and pull it off.
The screw wont likely have fallen past the end bell screw ring Take the brush springs off Take the brushes out Undo the two screws holding the end bell down Pull the end bell off |
|
|
|
 |
|
||||||
| Bookmarks |
|
|
 |
|
