m24 project concluded

[the man behind the rifle]

Hello I have finally finished my classic army m24.
I will brake this up into 2 parts, all talk about the 1400$ blowgun and then I will talk about all my orders.


Well I will start off by talking all about the performance and the small diy mods I’ve done. The stock its very nice and I added a nicely built cheek rest that I made out of foam. I moded my G&P bipod to mount backwards on the second stud to make it closer to me for when I have to "quick detach" and it helps the overall look. For optics I have a leapers 4-16x50 and still needs a bit of adjusting . All of the internals are pdi and most are listed down there ↓. The only things that have been left stock are the ca trigger unit and the decent ca bolt end cap . I have 6 spacers but I noticed that when I installed them (due to the incredibly tight fit) the spacers would slide down so I just put some tape and noise dampening foam behind each spacer and that seemed to work well . I replaced the hop up spring with another one of the same strength and all this does is increase surface contact area on the outer barrel to make it more stable. For lubricants I cleaned off all the old grease and applied silicon spray ( for airsoft use) to all the parts , also cleaned out the barrel. I have not crono’d it yet but id say its shooting around the 500 mark. I am getting consistent lazzer shots of 215 ft and I can hit 280 -300 by arcing it ( BBs are green devil .30’s) .

Now all talk about xfire. There service was so remarkable it chocked me. I ordered all my parts in two orders to make sure I don’t get scammed, ect . The first order was my hop up unit, the bucking, 05 barrel , 4 spacers, ball & springs and my sus sandblast handle. The second was my palsonite VC cylinder set and 240% spring. Also the lengthened Allen key . both orders arrived within 5 days of ordering and I did not pay any tariffs. This was a big relief a for me because I have had bad experiences with ordering overseas in the past but this one worked well. I think I mentioned it in another thread but I ordered my M24 from airsoft Alberta.


All end this by saying thanks to everyone who helped improve\ influence my decisions and for any questions I had answered. I hope this helps anyone that had the same questions I did. Pictures will be up within the week.