New Hop Up Bucking-Modify

[bebebee]

Dear Friends,



Modify has new Product!!!! Accurate Hop Up Bucking for VSR-10, TM Hi-CAPA, M1911A1, SIG P226, SOCOM MK23, GLOCK 26 Series will be available in a week. It is made from 1st Class Aircraft Rubber with some special material added in. It’s very accurate and consistent for shooting, improved air seal and with excellent extreme temperature properties






Material: aircraft rubber
1st Class Aircraft Rubber
1 GRADE of HOP UP BUCKING…ACCURATE

Features;
1) Excellent extreme temperature properties
2) Improved air seal
3) Excellent compression set
4) Superior tear resistance
5) High abrasion resistance

TEST REPORT – Modify Accurate Hop Up Bucking
For VSR-10, TM Hi-CAPA, M1911A1, SIG P226, SOCOM MK23, GLOCK 26 Series


The MODIFY Accurate Hop Up Bucking was tested on a Tokyo Marui VSR-10 and a Tokyo Marui Hi-CAPA 4.3 using the following equipment and conditions:

BB: 0.2g
Chronograph: XCORTECH X3200 (serial: T0133)
Spring: Marui stock spring ( Under 1 Joule)
Average Temperature: 27℃
Measurement: FPS/ Joule

Your results will vary from these published results. Different upgrades will provide different results. The data contained in this chart should only be used as a reference.


Data Chart – Tested on Marui VSR-10 1


Data Chart- Tested on Marui Hi-CAPA 4.3 1

[Sequential]

Where to buy?

[Forever_kaos]

Originally Posted by Sequential

Where to buy?

http://www.airsoftparts.ca/store2/in...oducts_id=2264

[MASAKO]

Any body has a review yet ?

[ThunderCactus]

Do they have one for over 400fps, or are they only making these for pistols?

[krap101]

Is it just me or is the fps variation bothersome?

[ThunderCactus]

Originally Posted by krap101

Is it just me or is the fps variation bothersome?

1/3 is about where i have my hop adjusted, that's where it's optimal. And that's where the least variation is.
It's definitely going to vary more at higher and especially at zero adjustment.

But it could be the fact it's a stock rifle as well. I'd have more confidence on the test if it was done on a PDI upgraded VSR, then you know the airseal is excellent.

[krap101]

Stock would explain it. I suppose the problem is that there isn't a comparison/baseline to compare to, because looking again, 5fps isn't that bad. Maybe if you had some fps tests from a nineball or a firefly (the "normal" vsr nubs), you could rule out the gun as the variable. One thing that is confusing me is higher hopup setting normally leads to better compression?

Edit: Woops, I didn't see this was a promotion thread

[turok_t]

Anyone try this on pistols ? I'm interested to try thisom hicapa and glock

[ILLusion]

I have some inbound to try

[Sequential]

Originally Posted by ILLusion

I have some inbound to try

I'm down, drop me a line! :tup: