|
|||||||||
|
Home | Forums | Register | Gallery | FAQ | Calendar |
Retailers | Community | News/Info | International Retailers | IRC | Today's Posts |
|
Thread Tools |
December 24th, 2008, 01:07 | #1 |
Need help installing an M203
Hey guys,
Recently got myself a G&G M-16A3 from Ken at 007. Really nice rifle, very happy with it. I can | | this close to being able to fully install the launcher i have, however i ran into a snag, being that I cant figure out how to remove the barrel so I can slide the rear end of the launcher over it. No obvious bolts or anything, so im honestly at a loss. Was able to remove the handguards and the d-ring, and then hit a wall, as this one is unlike the previous A2 I had that was different and easier to disassemble. Anybody have any experience with these guns? Thanks! |
|
December 24th, 2008, 01:10 | #2 |
Captain Awesome
|
usually you install from the front. remove the flash hider, knock the trisight pins and set screw out (underneath sling loop) slid that off, slide gl on and reverse process.
|
|
Bookmarks |
|
|