VSR-10 clone problem : BBs fall from barrel...

[Silverthorn]

Hello,

I own a VSR-10 clone (it's actually a HFC USR-11).

When I purchased it I had problem getting the BBs to feed. I did many checks based on forums suggestions here and it ended up being a magazine problem. Needed to use a marui mag. Easy fix

Now, since I did those checks I have another problem : after I pull the bolt and push it back to get ready for a shot the BB loads properly but then fall off the barrel by themselves before I even shoot. It falls when I push back the bolt. This didn't occur until I opened up the section where the hop-up is located (I did managed to get BBs to feed sometimes so I know it wasn't happening then).

Any idea what I should look at ?

[bean]

Take the hopup and barrel out and move the hopup adjuster back and forth while looking into the barrel. You should see a section of the hopup move in and out as you do this. If you do not your likely missing a part. Look at my thread in the upgrades section for detailed pictures.

[Silverthorn]

Yep you are right, I don't see any movement.

Fixed now. Sir, you truly are a wizard. Many thanks!

[bean]

Any time