|
|
|
|
|
||||||||
|
|
|||||||||
| Home | Forums | Register | Gallery | FAQ | Calendar |
| Retailers | Community | News/Info | International Retailers | IRC | Today's Posts |
 |
|
|
Thread Tools |
January 10th, 2008, 11:27
|
#1 |
|
What Gears have you used in an ICS?
Been looking around and havent found too much so I hope the ICS users on here have some better info on what I am looking for.
Thanks in advance for your replies. Also motor info as well if possible. And does your bevel have more than 2 Anti-Reversal Catches on it?
__________________
No Comment. Last edited by HaZarD SFD; January 10th, 2008 at 11:50.. |
|
|
|
January 10th, 2008, 11:46
|
#2 |
|
ZS-02-10 (systema ordinary flat gears)
__________________
   
|
|
|
|
|
January 10th, 2008, 14:59
|
#3 |
|
ICS-only if you ICS steel or copper bushings. If you change the bushings, use whatever you like. ICS uses a smaller axle hole than everyone else, so their bushings are too tight for other gears.
__________________
Age verifier Northern Alberta Democracy is two wolves and a sheep discussing what's for dinner. Freedom is the wolves limping away while the sheep reloads. Never confuse freedom with democracy. |
|
|
|
|
January 10th, 2008, 19:52
|
#4 |
|
|
hmm good to know.
__________________
No Comment. |
|
|
|
 |
|
||||||
| Bookmarks |
|
|
 |
|
