ksc g19 Cycling problem ***FIXED***

[DB19]

Hello I have replaced my broken trigger sear with one out of a kwa g19 and I am having problems. This is where it begins I installed a huricane trigger spring wich is stronger than the old one (to my knowledge) and my glock will cycle but the hammer wont stay back so I have to pull the slide back again just like a springer. Has there been any one else with this problem that can help me?

thanks

[ILL9MIL]

What gas are you using? if using 134a try GG/Propane

On 2 19s I had that broke their sears, the new sears needed to be worked a bit. I took the slide off and manually cocked and decocked the hammer to wear down the unused sear a bit.

Good luck

~ILL

[DB19]

I am using propane and I think I might have found the problem but not sure untill I try it I think it is the trigger spring it isnt pulling the trigger back into place after each shot but as for the trigger sear it is from an old glock so im pretty sure its worn in

thanks

[DB19]

No luck on the spring theory I think it might be the trigger bar like jonnydo said in another thread because my gun is now full auto so I am going to get ahold of jonny or tex because Im pretty sure they both have gone through this but if any body else knows how let me know thanks

[DB19]

FIXED turned out it was the hammer bar was bent thanks to the good advice and help from jonnydo anything glock visit him at his store or online :cheers:

[JohnnyDo]

Thanks for the props man, anything I can do to help as many have done for me.