Gate Merf 3.2 problem

[Carlito564]

I just finished installing the Merf 3.2 using the single thin wire to one trigger tab and the two red positive wires to the other trigger tab but it won't shoot. I've gone through the programming to where I want it to be but upon trigger pull the gun won't shoot. I've been stuck here for hours looking for answers and trying different things to no avail.
Also, since my gun is wired to XT60 connectors I made adapters for XT60 to deans. I don't know if that'll make a difference or what but I'm putting it out there.

[Hectic]

After you program did you unplug the battery plug the motor back in then the battery?
What is happening when you pull the trigger nothing at all or does the motor seem to wanna go but just clicks a lil?(ie the polarity is reversed via one of your adapters so its tryin to spin the motor in reverse)
Are all your plugs plugged?
Is the connection at the trigger with the two motor wires still in tact?
Maybe try the 2 signal wire method instead that worked fine on mine i never tryed the 1 wire method

[Wrath144]

Try the other trigger wire port.

[Carlito564]

Thanks for the input. Tried them all and found that the signal wire came off of its connection on the trigger. After a quick fix its working beautifully and I have to say that the 3 round burst is absolutely beautiful. <3