Tanio Koba / KJW M4 GBBR Basic Information and FAQ

[Amos]

A machine shop

[Gato]

Originally Posted by Amos

A machine shop

Amos, he said more specific! Like this: Preferably a local machine shop

Haha, Amos is right, a machine shop, he can't get much more specific

[Thenooblord]

well "A machine shop" literally means nothing to me
as in, place that manufactures stuff? or a place that sells machines of some sort?

[Amos]

Originally Posted by Thenooblord

well "A machine shop" literally means nothing to me
as in, place that manufactures stuff? or a place that sells machines of some sort?

A shop, that specializes in machining

... Fuck this is too complex.

http://lmgtfy.com/?q=Machine+shop+around+Toronto

Hope this helps.

[LocoYokoPoco]

So, anyone know of any magpuls that would work with the KJW M4 mags?

Also, does anyone know where I can find an extra loading tool, just in case?

[Thenooblord]

i just took the magpuls off my friends stanag mags and they were a tight fit but they did go on

[LocoYokoPoco]

So Today I stress tested the gun. Shot 6 mags on full auto one after another. The bolt was partially covered in a sheet of what appeared to be ice/snow. Still works though and the bolt locked everytime. I'm impressed.

[andrew321]

Had my first fail at a game this sunday. Was about 30 degrees out, so it was kickcing hard. (reduced to 300 to keep it safe).

The o-ring on my cradle piston came off, and the end of my piston is bent and smashed. I replaced the o-ring, and it shoots fine again. Not sure why this happened, as it was completley lubed up.

Round count was at about 12,000.

[AfroNinja]

anyone know if you need special tools to install this (ie: barrell nut tool) http://airsoftdepot.ca/catalog/produ...roducts_id=308 or any other DD replicas?

[baker_Jeff]

Just hex keys.

[Thenooblord]

im having better luck with the stock piston head than the cradle ones, ive smashed my cradle one and broken both the orings and the original is still in (worn) but serviceable condition

[Amos]

Originally Posted by Thenooblord

im having better luck with the stock piston head than the cradle ones, ive smashed my cradle one and broken both the orings and the original is still in (worn) but serviceable condition

... Yea but you break everything in completely inexplicable ways..

[LocoYokoPoco]

I'm having a few issues with mine Semi auto doesn't cycle properly (trigger doesn't reset after each shot), and the charging handle "blows back" when firing as well :/

[kolumbo69]

Talk to T_hum on arnies ( I thinks thats his handle) he is the man behind cradle airsoft he should be able to give you some ideas or even a new piston if it isn't working right

[Thenooblord]

I just totally took apart and cleaned the lower assembly, and after 15-20K shots fired i discovered a surprisingly nonexistent amount of wear, seriously, the ONLY wear of and of the internals is where the bolt slides on the hammer, otherwise all thats gone is the outer coating on hte heavy contact points of the hammer, but the trigger and sear are like the day they were made, and no wear on the bolt carrier or bolt catch
God damn I love this thing...