C-TAC VSR 10 disassembly help

M. Mackey · December 11th, 2012, 18:07

I've been trying to get the cylinder out of my C-TAC VSR-1,0 but the little catch on the bolt side that's supposed to flick down is
extremely stiff and I cant get it to disengage. Can anyone help me with this? I'm trying to remove my cylinder group to clean and re-grease.

SuperHog · December 11th, 2012, 20:32

Directly in front of thr trigger is a bar that locks the spring guide during cocking. That needs to removed. It is stopping from removing the cylinder.

The other quick way is remove the trigger assembly completely with two screws.

M. Mackey · December 13th, 2012, 16:55

I tried both. The bar that locks the spring is extremely hard to move. I tried pliers and a hammer and it wont move. Also I tried removing the screws and removing the entire trigger assembly and it seems to be still attached somehow =\ Any other ideas?

M. Mackey · December 13th, 2012, 17:03

Ok, Nevermind. Finally got it open with a little extra elbow grease. Thanks for the help!

Home	Forums	Register	Gallery	FAQ	Calendar
Retailers	Community	News/Info	International Retailers	IRC	Today's Posts

British Columbia	Alberta
BCAC	EAR
Op-For	JOC
Northern Arms Airsoft	Skunkworx Airsoft
Airsoft Kelowna	RAAT
Prince George Airsoft	Manitoba
Saskatchewan	MAA
SK Airsoft	Ontario
PDW	Airsoft Ottawa
South Sask Mercs	Snow Dragons
Quebec	1st Ranger Platoon
PQAC	Wolfpack Tactical
1st Pathfinders Regiment	TTAC3
Quebec Airsoft
MTX Airsoft	Atlantic
FAQc	Atlantic Airsoft

December 11th, 2012, 18:07	#1
M. Mackey Trader rating Join Date: Dec 2012 Location: St. John's NL	C-TAC VSR 10 disassembly help I've been trying to get the cylinder out of my C-TAC VSR-1,0 but the little catch on the bolt side that's supposed to flick down is extremely stiff and I cant get it to disengage. Can anyone help me with this? I'm trying to remove my cylinder group to clean and re-grease.

December 11th, 2012, 20:32	#2
SuperHog Trader rating Join Date: Jul 2011 Location: Toronto, Ontario	Directly in front of thr trigger is a bar that locks the spring guide during cocking. That needs to removed. It is stopping from removing the cylinder. The other quick way is remove the trigger assembly completely with two screws. Last edited by SuperHog; December 11th, 2012 at 20:38..

December 13th, 2012, 16:55	#3
M. Mackey Trader rating Join Date: Dec 2012 Location: St. John's NL	I tried both. The bar that locks the spring is extremely hard to move. I tried pliers and a hammer and it wont move. Also I tried removing the screws and removing the entire trigger assembly and it seems to be still attached somehow =\ Any other ideas?

December 13th, 2012, 17:03	#4
M. Mackey Trader rating Join Date: Dec 2012 Location: St. John's NL	Ok, Nevermind. Finally got it open with a little extra elbow grease. Thanks for the help!

C-TAC VSR 10 disassembly help

Airsoft Guns Discussion