|
|||||||||
|
Home | Forums | Register | Gallery | FAQ | Calendar |
Retailers | Community | News/Info | International Retailers | IRC | Today's Posts |
|
Thread Tools |
January 10th, 2007, 19:47 | #1 |
Bearing Bushings shimming
I am just starting to open up guns and have attempted to install a set of gaurder bearing bushings on a V3 with stock TM gears but I had a really hard time getting them on. Is there some magic method that gets them on and off easily to shim? Some go on allot harder then others. I should have payed attention to which gears were tight fitting but it was late.
__________________
age verifier for Prince George, Mackenzie, Quesnel, Fort st James and northren BC http://pgairsoft.goodforum.net/index.forum |
|
January 10th, 2007, 19:51 | #2 |
Official ASC Bladesmith
|
I use a small hammer ot tap them flat, then try to get them out. That generally opens them up a small sliver, sometimes doesn't. As long as they are perfectly flat shimming is easy from there, but I always find it a lot easier to fit the mechbox halves together all the way with the bushings for the top cover side of the gears sitting on the gears themselves. A LOT easier to line up a large circle into a large hole than to try to get a small circle you often can't see well into a small circualr hole.
Good luck! |
January 12th, 2007, 12:53 | #3 |
thanks..
__________________
age verifier for Prince George, Mackenzie, Quesnel, Fort st James and northren BC http://pgairsoft.goodforum.net/index.forum |
|
|
Bookmarks |
Thread Tools | |
|
|