|
|
|
|
|
||||||||
|
|
|||||||||
| Home | Forums | Register | Gallery | FAQ | Calendar |
| Retailers | Community | News/Info | International Retailers | IRC | Today's Posts |
 |
|
|
Thread Tools |
March 25th, 2020, 11:02
|
#1 |
|
Aster installation issue - help needed!
I have installed Aster MOSFET and I don't have any response when I press the trigger. It gives 3 motor beeps when I connect the battery and the LED next to the trigger sensor flashes RED and YELLOW rapidly 3 times and then turns off. I don't see white light coming from it as shown on promotional pictures. When I do it with the gearbox opened the trigger sensor reacts to the light - if I shine the light on it, motor beeps and the other LED flashes RED and YELLOW again. I do have to mention that I have purchased front a wired unit and resoldered it to be a back wired. Any advice would be very much appreciated.
|
|
|
|
March 27th, 2020, 10:37
|
#2 |
|
It's possible either too high or too low of a voltage battery or mah or max draw rating, or wrong type of battery (I had a similar issue with a titan MOSFET while using an 11.1v LiPo, which was rectified by using a 7.4)
__________________
current armament: mk43, ump.45, p90, barret, m14, g33, k98, m4 tac, m4 swat, mp5 navy, vsr10, p226, m9.
|
|
|
|
|
|
March 27th, 2020, 10:38
|
#3 |
|
One other possibility is that you reversed the wires when resoldering by mistake
__________________
current armament: mk43, ump.45, p90, barret, m14, g33, k98, m4 tac, m4 swat, mp5 navy, vsr10, p226, m9.
|
|
|
|
|
 |
|
||||||
| Bookmarks |
| Thread Tools | |
|
|
 |
|
