Front-wiring with RAS Float Tubes - How do you hide your wires?

[mroneto]

Seeing as how some float tubes (specifically LaRue models) have smaller diameter holes than some other brands, how would you recommend hiding the wires from the attached PEQ box?

As it stands, I have my box on the top rail, but with an extension wire running around the front edge and wrapping around to the inside, along the barrel.

The deans plugs are wrapped in black electrical tape and sit along the inner side of the Magpul XT panels on the side, which actually conceals them very well.

While highly unrealistic, this setup works fine in terms of functionality and takedowns (if required).

However, with a better PEQ-15 on the way, and wanting to make this front end a little bit more aesthetically true, I want to know the best way to conceal and/or route the wiring to make it look like a tapeswitch or pressure pad.

Feel free to post pics of your front-wired guns and how you worked around this issue.