|
|||||||||
|
Home | Forums | Register | Gallery | FAQ | Calendar |
Retailers | Community | News/Info | International Retailers | IRC | Today's Posts |
|
Thread Tools |
May 1st, 2008, 13:44 | #16 |
just got mine today!
|
|
May 1st, 2008, 15:42 | #17 |
Monkey with a Gun
|
mech box
I installed mine in a reinforced King Arms 7mm box for Betsy. They fit nice. there was some sanding and some slight modding but they sure work nice. I love the fact when you need to check or clean the box they make life so much easier.
__________________
"Anyone who has the power to make you believe absurdities has the power to make you commit injustices." Voltaire AV for Barrie, Orillia, Innisfil, Bradford Region - pm me if you need AV'd I'm the Barrie Bastard. http://www.bbbastard.com/ Cheese is good. |
May 1st, 2008, 16:24 | #18 |
Bought Crunch's extra BNIB set of the torque up gears and must say the shot response went up quite nicely. Noise factor is about the same, I'm running a Ver.3 AUG so I dunno if it's the natural amplifying characteristics of the buttstock or what.
One of the smaller but really awesome improvements in this gearset is the E-clamp/clasp whatever that keeps the spring on the anti-reversal latch from popping up when you put the mechbox back together. Also nice is the ability to release the spring tension with a small screw driver by twisting the anti-reversal from the outside.
__________________
Various BB throwers |
|
May 1st, 2008, 16:26 | #19 |
ok I decided to get a set. Where did you guys buy them? PM me if you are selling a set of high speed for ver 3 mechbox.
__________________
|
|
May 1st, 2008, 16:46 | #20 |
Guest
|
http://www.airsoftparts.ca/store2/in...roducts_id=690
I have em in my kraken , so far there great, I got the Hight torque set up. Be careful with the hi speed make sure you have a quality piston and make sure your getting good engagement from the sector gear with the piston. My setup with all my guns is a Titanuim full steel rack piston with a ground out 2 teeth. Last edited by pawscal; May 1st, 2008 at 16:50.. |
May 2nd, 2008, 14:58 | #21 | |
Quote:
Skruface thanks for that detailed info you posted at filairsoft.
__________________
Last edited by Syn; May 2nd, 2008 at 15:24.. |
||
May 2nd, 2008, 16:34 | #22 | |
Guest
|
Quote:
I cant comment on the modify piston because I never used one however I would rather have a all steel rack piston instead and just do a little work with a grinder. I say get the gears on special and grab a deepfire titainuim piston. |
|
May 2nd, 2008, 17:09 | #23 | |
Quote:
http://www.airsoftparts.ca/store2/in...roducts_id=746 http://www.airsoftparts.ca/store2/in...roducts_id=691
__________________
Last edited by Syn; May 2nd, 2008 at 17:34.. |
||
|
Bookmarks |
Thread Tools | |
|
|