|
|
|
|
|
||||||||
|
|
|||||||||
| Home | Forums | Register | Gallery | FAQ | Calendar |
| Retailers | Community | News/Info | International Retailers | IRC | Today's Posts |
 |
|
|
Thread Tools |
June 11th, 2013, 08:37
|
#1 |
|
Moving_target
|
Anti Dry fire magazine mod help for VFC MP5
Hey looking people that have knowledge with VFC mp5. I saw the forum link to ra-tech that explain for 3 seconds that there is a piece that you can replace in the magazine to make it anti-dry-fire
Any that added the magazine piece to make anti Dry fire tried it? How well does it work? I want to know because I might buy about 15 of them for my co2 mags |
|
|
|
June 12th, 2013, 01:14
|
#2 |
|
I believe it's a magazine follower. Unless Ratech has something new? You should have one come with your mag. When running out of bbs, this piece blocks the nozzle moving forward. It works good.
Personal I don't like the design. It's hard to change the piece. Also having high impact on follower and nozzle. If you don't have a reinforce follower, it may not function after a period of time use. Even the nozzle too. Finally I remove them.
__________________
aka Uncle 
Last edited by N_Force; June 12th, 2013 at 01:18.. |
|
|
|
|
June 12th, 2013, 11:03
|
#3 |
|
Moving_target
|
thank you for your response
do you know where I can buy 15 of them? |
|
|
|
|
June 12th, 2013, 13:21
|
#4 |
|
|
http://airsoftcanada.com/showthread....hlight=vfc+mp5
http://airsoftcanada.com/showthread....hlight=vfc+mp5 Check these might help
__________________
aka Uncle
Last edited by N_Force; June 12th, 2013 at 13:25.. |
|
|
|
|
June 13th, 2013, 02:20
|
#5 |
|
GBB Whisperer
|
I have a bunch of the reinforced ones available, but even those ones couldn't hold up to the impact of the bolt after a few times. Ultimately, it's a stupid design, and I've just decided to run without them.
|
|
|
|
 |
|
||||||
| Bookmarks |
| Thread Tools | |
|
|
 |
|
