|
|
|
|
|
||||||||
|
|
|||||||||
| Home | Forums | Register | Gallery | FAQ | Calendar |
| Retailers | Community | News/Info | International Retailers | IRC | Today's Posts |
 |
|
|
Thread Tools |
July 16th, 2012, 14:23
|
#1 |
|
TM hi capa hammer issue not returning
Hello!
I have recently started a new build and assembled everything together. The hammer cocks back but when I pull the trigger it only returns about half way and it does not go fully back into position. As a result the firing pin does not engage. I took it all apart and could not find anything directly wrong. Has anyone encountered this issue? Any ideas? Thanks! - Topa |
|
|
|
|
July 16th, 2012, 15:32
|
#2 |
|
possibly your leaf spring is not installed properly. just seat it properly.
__________________
"May you fight with the strength of ten full grown men." |
|
|
|
|
July 16th, 2012, 16:50
|
#3 |
|
I checked that out as well and it is perfectly aligned.
- Topa |
|
|
|
|
|
September 17th, 2012, 14:25
|
#4 |
|
is it a custom lower frame that you are using?
|
|
|
|
|
|
September 17th, 2012, 14:41
|
#5 |
|
Yes it was. And it turns out that it was an issue with the disconnector I was using. It was shaped ever so slightly different than the usual tm one so I just switched it out.
- Topa |
|
|
|
|
 |
|
||||||
| Bookmarks |
| Thread Tools | |
|
|
 |
|
