I have a Kenwood Tk-370 and after some of the latest big storms, my fiance asked me if I could tune into enviroment canadas weather radio alerts.
http://www.msc-smc.ec.gc.ca/msb/weat...ct_sheet_e.cfm
now the site says I need to tune into freq 162.550 MHz.
Quote:
Pressing (TA) will allow you to program Frequencies
Use selector to choose channel
Press PTT
Enter Rx frequency using:
- the Selector Knob to change kHz;
- the Selector Knob + (light) to change MHz.
If no channel is Shown press the (LO) button.
Press PTT
Enter Rx CTCSS code
Press PTT
Enter Tx Frequency as above
Press PTT
Enter Tx CTCSS code
Press PTT
1. Option Signal
Off
1 = DTMF
2 = 2-Tone
2. PTT ID
On
Off
3. Add/ Del
4. Busy Tx
5. Clock frequency shift
6. Power
Hi
Low
|
now, I havent done this before
Pressing (TA) will allow you to program Frequencies
Use selector to choose channel
Press PTT
Enter Rx frequency using:
- the Selector Knob to change kHz;
- the Selector Knob + (light) to change MHz.
If no channel is Shown press the (LO) button.
I enter 162.550 MHz
Press PTT
Enter Rx CTCSS code
Any idea what i put here?
Press PTT
Enter Tx Frequency as above
I keep it at 162.550 MHz
Press PTT
Enter Tx CTCSS code
Any idea what i put here?
Press PTT
1. Option Signal
Off
1 = DTMF
2 = 2-Tone
Any idea what i put here?
2. PTT ID
On
Off
Any idea what i put here?
3. Add/ Del
Any idea what i put here?
4. Busy Tx
Any idea what i put here?
5. Clock frequency shift
Any idea what i put here?
6. Power
Hi
Low
any help would be nice. Im not 100% sure what all these things mean, and finding a lamens-term guide is harder then I though for this.