Quote:
Originally Posted by EOD Steve
Can you say without a shadow of doubt, that it was part failure and not installation error?
Because if the latter, you may want to re-visit using cheaper parts to nail down your workmanship/process before throwing money at problems.
|
See thats what I'm considering too in all honesty I'm not ashamed to say it I believe it was 1. My shimming job. 2. Parts not meshing mainly contact due to the shimming job but also the Tienly pinion not liking the SHS bevel. 3. AOE which was my fault. So my question is what should I try parts wise I'm more than happy with SHS gears so maybe I should try them again but bushings or bearings etc.. Brands to try etc.. Also i should mention this happened at about 45rps I did a quick burst and big failure.