Quote:
Originally Posted by GBBR
the housing which holds the the Smooth Gearset elevates the gearset just enough for it not to engage the electronic cut off switch, this problem can be overcome by shimming the mosfet by 0.3mm ( inside a modifiy gearbox ). HOWEVER this solution will only cause another problem, you must now add mass to the selector plate until it can engage those little switchs its really dumb
|
A more "efficient" approach would be to unsolder the cut-off switch, place a shim under it to raise it (plastic) and then resolder it in place.
You would need to be able to do such small solering job.