Airsoft Canada - View Single Post

mcguyver · September 1st, 2013, 23:56

I will clue you in a bit here. The motor is not the only part of the PTW that would be affected if you submerged it in water, or allowed water to penetrate and stay within the motor. Or debris, conductive or not.

The PTW open frame motor is not high tech whatsoever, in fact, it is very low tech, and most of the motors I work on are between 10 to 1000 times more costly (yes, that is correct). Brushless motors are not used in modern airsoft guns, and there is a reason why.

It is due to size vs performance. Sme guns youmaynbe able to get away with it, but most you won't.

I have read the questions you have asked here on PTWs. The fact that you have asked them means that the basics behind this design you do not yet understand. Do with them as you wish, I have said my piece.

September 1st, 2013, 23:56	#301
mcguyver Trader rating Join Date: Aug 2005 Location: Northern Alberta	I will clue you in a bit here. The motor is not the only part of the PTW that would be affected if you submerged it in water, or allowed water to penetrate and stay within the motor. Or debris, conductive or not. The PTW open frame motor is not high tech whatsoever, in fact, it is very low tech, and most of the motors I work on are between 10 to 1000 times more costly (yes, that is correct). Brushless motors are not used in modern airsoft guns, and there is a reason why. It is due to size vs performance. Sme guns youmaynbe able to get away with it, but most you won't. I have read the questions you have asked here on PTWs. The fact that you have asked them means that the basics behind this design you do not yet understand. Do with them as you wish, I have said my piece. __________________ Age verifier Northern Alberta Democracy is two wolves and a sheep discussing what's for dinner. Freedom is the wolves limping away while the sheep reloads. Never confuse freedom with democracy.