Airsoft Canada - View Single Post

Ninja_En_Short · August 11th, 2013, 00:31

Hi all,

As you may or may not know I design some gear from time to time and my lastest creation is a custom G36K handguard, I started working from a model of regular G36KV handguard :

I designed it so it can accept MOE rails with a groove inside it so the eliptical support of these rails don't turn on themselves, you could do the same with regular nuts:

If you notice the holes in the lower part don't go all the way back that's because I wanted to provide some protection to the battery and not damage the plastic wrapping around.

Overall I designed that thing to give a more aggressive look and fix an issue I have on my RS : because the holes in the standard rail are quite small and the hand guard folds on itself at the end the heat tends to stay in. With the huge venting holes on all sides the problem can be fixed.

That thing will be made for airsoft though and given I can get it directly in ABS+ the nerd I am will probably get it 3D printed

It's not 100% done, I have to get the exact measurements for the rails and fine tune the design but that's the design I'm going for.

Thoughts ?

August 11th, 2013, 00:31	#1
Ninja_En_Short Trader rating Join Date: Jul 2007 Location: France, Canada (Montréal)	Custom G36K handguard Hi all, As you may or may not know I design some gear from time to time and my lastest creation is a custom G36K handguard, I started working from a model of regular G36KV handguard : I designed it so it can accept MOE rails with a groove inside it so the eliptical support of these rails don't turn on themselves, you could do the same with regular nuts: If you notice the holes in the lower part don't go all the way back that's because I wanted to provide some protection to the battery and not damage the plastic wrapping around. Overall I designed that thing to give a more aggressive look and fix an issue I have on my RS : because the holes in the standard rail are quite small and the hand guard folds on itself at the end the heat tends to stay in. With the huge venting holes on all sides the problem can be fixed. That thing will be made for airsoft though and given I can get it directly in ABS+ the nerd I am will probably get it 3D printed It's not 100% done, I have to get the exact measurements for the rails and fine tune the design but that's the design I'm going for. Thoughts ? __________________ Tous les jours nous nous endormons plus instruits mais pas forcément moins bêtes... I can do a CTRL+ATL+DEL on your gun ! Gun doc in Montreal on AEG, GBB, GBBR and Bolt rifle (gaz and spring) Heavy custom builder (including painting) Last edited by Ninja_En_Short; August 11th, 2013 at 19:05..