Quote:
Originally Posted by R.I.T.Z
remove the internals from the cqbr and put them into the sr16 and viola done
|
Nope not easy I have found out
1. CQB (cas version upper does not fit a SR-16) full tear down required
2. Barrel does not fully engage into a SR-16, just about 2mm off, my fix grind off 2mm from gas tube (to fit the rails)
3. Watch that wire placement on rear, need to grind a clear channel
Tools required for this change
small mallet, flat blade screw driver, small punch, needle nose pillars
Special tools, A #2 Phillips screw driver at least 8" long to remove crane stock
Snap ring pillars to remove the barrel
before
After
