Quote:
Originally Posted by simohayha
hmmmmm ok, ill try swapping parts then. by the way do u know whether PDI delta hammer works with prog4 hammer assy (sear,spur,etc), cause i really want delta style hammer and my prog4 ones is ring type.
|
I do not personally know, as I've never tried that hammer before, but I don't see why it wouldn't function.
For what it's worth, it's recommended to never mix brands of hammers and sears, unless you are absolutely certain that both parts are made of materials that complement each other in Hardness Rating. Otherwise, the softer of the two components will wear down the other part quicker, which will result in a safety issue. For example, if the PDI hammer is made of a softer material than the ProG4 sear (it is China-grade P20 steel), then the ProG4 sear will eat the hammer hooks of the PDI hammer which can cause uncontrolled full auto fire, burst fire, or accidental discharges if you bump the gun.
Quote:
Originally Posted by spartan117
So Illusion, the half cock pin allows the Half cock function on a hi capa? Does it inhibit one from decocking the hammer?
|
Correct on both counts.
As a side note, one should always be careful when manually decocking a 1911/2011, and be mindful of the magazine status. If a gassed magazine is inserted and you manually decock, there is potential for the slide to blowback and clip your thumb. Not fun if you're running a metal slide, high flow valves and propane. You could say "bye bye thumbnail".... as well as whatever was in the path of the muzzle when (if) a BB is fired on this accidental discharge.