Quote:
Originally Posted by Sportco
Yes that is the spring and what you descrived is what I was expecting when I did it... but for some unknown reason mine never moved back out of place...
Because this is a poor quality metal casting, I wouldnt risk a dremel on it, if it were to break... that would be an unpleasant situation
Just an idea... Since you might have to fine tune the spring position, why dont you put something like a coat of silicone adesive or 5 minute epoxy on the bar let it cure, then seat the spring without damaging it... because both these stuffs are flexible, the spring will digg in and lateral slip will probably be eliminated
or better yet... wedge the spring between two tight o-rings so you can reposition need there be
Cheers... glad it worked!
|
Thanks for the suggestions I'll check with Canadian tire to see if they have silicone adhesive or 5 mintue epoxy.