mags for the AGM HK 416
 

Ok so i own AGM HK 416 and i have decided to buy 10 packs of 75 round of Pmag from ehobbyasia. So when i got the mags i fill them up with bbs and insert them into my HK 416. However it doesn't go all the way in and don't feed into rifle. can any one help me out here????

due to the lower angle of the mag well on the 416, the front of the Pmag catches on it.
the only real solution is to file down the fron inside edge (10-15mm square area, 3mm deep at the edge.) of the magwell. there isnt enough material on the front of the mag to file off, or you'll end up with a hole on the mag.

so then which brand of mag that works with my HK 416???

Any M4/M16 series mags that are NOT PMAGs should work.

alright then and i got one more question about mags. i was wondering that if m4 c-mag would work on my HK 416??

with the C-mag it's the same problem as the Pmags.

you could try KA mags. My classic army m4 had the same problem with pmags being too big, but I used KA mags for it now, and they work fine.

King Arms plastic midcaps work perfect in AGM HK416