![]() |
Magpul MIAD pistol grip
I have read in several places that modifications are required to make these fit properly, and indeed, the one I purchased doesn't mate fully.
Although I've read frequently that modifications are required, I have yet to see any description of the modifications required. Could someone please assist me with this? The symptom is, simply, that the pistol grip does not seem to cover the entire mechbox assembly. Someone said something about the bushing interfering. No bullshit replies, please. If you know how to fix this or where the information lies, please let me know. |
It's going to vary a bit from one gearbox/body combo to another, generally you want to shave the inside of the grip, near the top. There's a track on each side of the grip that slide into grooves on each side of the gearbox. You want to shave those tracks down a bit.
|
you mean shave them down at the TOP or the overall thickness? The grip slides on ok, but it seems to stop well before the end of the tracks in the mechbox.
|
What kind of gun are you installing it on Morb? I had a problem with my Miad grip with my TM SR.. It appeared to go all the way on and straight, but no matter what I shaved off, that track, a little off the top, ect, I had motor allignment problems..
|
It's going on a Hurricane Shrike :)
|
I got mine to fit on after shaving down the area inside the grip right where the bushings are. After I did that it worked fine.
|
will it fit a PTW?....I placed one into my hand this morning and it felt very good and ergonomics was excellent for me...but on the top there is one little hole for a bolt to go throught, do you trim off all the area?...
|
Quote:
|
Quote:
Installed on a TM M4A1 with Systema gearbox shell. |
FIXED. I'd appreciate it if a mod could change the title from "assistance required" to "FIXED" and/or move it to the solutions section.
Thanks to those who came to the rescue. Essentially, the issue is the insides of the pistol grip butting up against the bushing that just protrudes beneath the lower receiver (if your mechbox is so equipped). The solutions is to dremel out grooves on both sides of the pistol grip, on the inside, about a quarter inch wide by an eighth of an inch deep so that the top of the grip will fit over the bushing and not interfere with it. Slide the pistol grip on as far as it will go, and mark the section where the bushing comes into contact with the pistol grip using chalk. Remove the grip, dremel out the channels and the grip will go on no problem. The channels don't need to go any farther down than the groove in the pistol grip. Pictures coming later. Thanks again guys! |
Quote:
|
Quote:
|
So does the airsoft version come with all the different customization parts like the real one?
|
Quote:
|
does it come with any? or is it just like the picture on airsoftparts.ca
|
They are just like on the picture. They are not in any way modular (sorry).
|
Of all the modular parts, I think most folks would use the upswept backstrap and front panel with a finger groove, which is what's on the PTS version anyway. You can add on the enhanced trigger guard separately.
|
+1 for this thread. Very helpful info.
|
Magpul MIAD pistol grip
Most of my 28 gauges have pistol grip stocks.I do have an AYA double with a straight stock.Speaking for myself I do find that the straight stock seems to be a little quicker on a rising bird.
|
Quote:
|
All times are GMT -4. The time now is 17:28. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.